Aluminium Boat Floor Can I Add A Resin To Seal Small Holes In The Hull Of An Aluminium Boat?
Can I add a resin to seal small holes in the hull of an aluminium boat? - aluminium boat floor
The hull is about 20 years ago and began to flee. He built a tank and tell me they can not be a soldier. The hole / holes in the tank, which can be removed without great difficulty, is located.
Jelp please.
|
4 comments:
You probably have a severe corrosion problem, and these holes are the first signs of an incipient fault.
You can use the temporary repairs that might be true in the short term use, but are a major problem in the future.
I might still allowed to stay in my boat, the internal fuel tanks. Too many questions remain, until a catastrophic failure hidden - sometimes I have to save these boats. Caches are only hidden (sometimes fatal) problems, rotting wait in silence, to stop the annoying, can be explosive, and always be expensive. They are a marketing tool, and give a feeling of less clutter and make the fuel load in the boat. Undoubtedly, the red, which they describe as the region is not broadcast - is perhaps the manufacturer, a layer of rubber or similar material under the tank to prevent strikes - this will still allow corrosion Foster - also question first.
You have two options. 1) Bite the Bullet, and properly adjusted. 2) Bog go of him and pretend
You should not use the resin to metal. You need a product called
Marine-Tex. These are two epoxy. It works very well for a short time in your case, since there is no flex to the rest of the body very well.
The only way to solve this problem is to move into the tank and weld the boat.
If you have a metal tank must now be examined during the case. Inside and outside.
When you replace a galvanized steel tank anyway. The galvanized coating is only reliable for about 15-20 years.
Replace it with plastic.
I
You should not use the resin to metal. You need a product called
Marine-Tex. These are two epoxy. It works very well for a short time in your case, since there is no flex to the rest of the body very well.
The only way to solve this problem is to move into the tank and weld the boat.
If you have a metal tank must now be examined during the case. Inside and outside.
When you replace a galvanized steel tank anyway. The galvanized coating is only reliable for about 15-20 years.
Replace it with plastic.
I
Can I assume that the tank is not leaking, but the water in the city under the tank. When this happens the most, epoxy, adheres to aluminum. Take some time to clean and repair adbrade area.
When the reservoir starts to lose, you simply remove all the fuel and then rinse with water. Now you can buy a tip / plastic containers from a store furniture.
Post a Comment